Watson-marlow 505U User Manual

505u-gb/3 505U 505U/RL

10Manual mode Learn and repeat mode 220StartStopPump speed is displayedAdjust speed and direction of rotation if necessary180To start pump operating

11English Manual Operation A User switch on power B When pump is switched on speed is displayed. (eg 220rpm) C Adjust speed and direction on pump ke

12Dosing speed adjust 505U Remote stop/Inverted remote stop response Dose will stop at end of countStopStopJ180Increase or decrease dosing speedL220

13Q Pump display will alternate between set speed and inverted remote stop response

14 # English Tube number Tube bore Double-Y Maximum cassettes rpm English Pressure (+) Suction Clockwise (rpm) Anticlockwise (rpm)

15313/314 (ml/min) Flow rates # 112 13 14 16 25 17 18 mm 0.5 0.8 1.6 3.2 4.8 6.4 8.0 " 1/50 1/32 1/16 1/8 3/16 1/4 5/16 313 55 1.7

16501RL, 501RLG, 313 Product codes mm " # Peroxide Silicone Platinum Silicone Marprene Bioprene 0.5 1/50 112 910.0005.016 91

17505L, 505LG (2.4mm) Product codes mm " # Peroxide Silicone Platinum Silicone Marprene STA-PURE Gore fluoroelastomer 1.6 1/16 119 910.E01

18Outline dimensions

19Product use and decontamination declaration In compliance with the UK Health & Safety at Work Act and the Control of Substances Hazardous to He

2Declarations Declaration of conformity When this pump unit is used as a stand alone pump it complies with: Machinery Directive 98/37/EC EN60204-1

3DO fit an extra length of pump tube in the system to enable tube transfer. This will extend tube life and minimise the downtime of the pumping cir

4• Change the set speed by pressing the ¿ or À key. The 505U speed control ratio is 110:1. This will give a minimum speed of 2rpm for the 220rpm driv

5• Turn the signal offset potentiometer clockwise to set the pump shaft speed to the desired minimum. • Set the process signal at its upper range lim

6• 220rpm 4.71kHz Learn and repeat The 505U incorporates a Learn and Repeat feature, which enables a dose to be memorised and repeated. The dose

7Fit the track in any one of three orientations, over the drive shaft and locating boss. Secure the track with the locating screw. Ensure the drive s

8Check moving parts of the rotor from time to time for freedom of movement. Lubricate pivot points and rollers occasionally with a light machine oil

9Drive spares Number Spare Description 1 US 0045 Mains connector 2 TF 0031 Transformer 3 SW 0086 Voltage selector switch 4 SW 0147 On/Off sw