Publication PB 0174 Issue 2 Drive/s: Issue 4 EPROM: N/A Pumphead/s: 603R Issue 1 Variable speed high-flow pump Installation and operatin
Page 10 Specification Nominal maximum rotor speed 165rpm Speed control range 5 percent to 100 percent Operating v
Page 11 Outline drawing
Page 12 Decontamination certificate Watson-Marlow Limited Health and Safety Declaration1.0This procedure is a legal requirement in the UK3.0Either
Page 2 Contents Declarations ... Page 2 Safety ... Page 3 Informat
Page 3 Safety In the interests of safety, this pump and the tubing selected should only be used by competent, suitably trained personnel after they ha
Page 4 Recommended operating procedures DO keep delivery and suction lines as short as possible. DO use the minimum number of bends in rigid pipe runs
Page 5 Part 1: Drive Siting To ensure correct lubrication of the gear box it is important to run the pump only whilst its feet are standing on a horiz
Page 6 Part 2: Operation Overview Start the pump by turning the forward/off/reverse switch on the left hand side of the front panel to the required di
Page 7 Part 3: 603R pumphead Tube loading Switch off the pump and isolate it from the mains supply before loading tubing. If the pump is not switched
Page 8 Adjustment of the pumphead rollers The two spring loaded rollers compensate for tolerance variations in the wall thickness of tubing, eliminati
Page 9 Pumphead spares MR 0574TSpindle - guide rollerMR 0283MHinge moulding5 requiredMR 0573TSpindle - main rollerMR 0601TColletMRA0010ARotor assembly
Comments to this Manuals